Pro Audio Support

Q:
Cannot copy multiple Automation parameters at the same time without copying the waveform in Pro Tools 5.0
 
A:
This is a known issue in Pro Tools 5.0



Other Popular Articles:
• What is DMA?
• Will any data be lost if I truncate a 24 bit file to 16 bits in MasterList CD after I apply a 16 bit dither to the 24 bit file in Pro Tools?
• In a 24 bit session should I apply dither during normalization or during the bounce to disk process?
• DAE error 39 or -39. Pro Tools will not launch and the system is some times frozen at the error. Trashing the prefs does not fix the problem.
• Where can I find the firmware version of my ATTO EPCI-DC card?