Pro Audio Support

Q:
When I powered up my PowerMac 9600 after adding a new drive to the internal SCSI bus, I heard a pop and now the system will not power on. I replaced the fuse but that didn't have any effect.
 
A:
This behavior was traced to a bad power supply in many instances.



Other Popular Articles:
• Can I sync a 44.1k or 48k session to the word clock output of a 192 I/O with a 96k Pro Tools session?
• Please locate 'filename.omf' when importing an embedded OMF exported from Avid Express Elite NT into Pro Tools 5.1.3 with Digitranslator 2.0.
• Session Counter and Big Counter do not reflect accurate SMPTE code. It either clocks the first frame it identifies and stops, gets ahead of or falls behind the clock in the Session Setup window.
• Pro Tools posts an invalid drive error when reading a session from a LaCie FireWire drive. Apple Drive Setup does not recognize the drive for formatting.
• When my 1622 is functioning in stand-alone mode, signal routes through the box normally...but when I launch Pro Tools and try and route any of these signals into ANY session at ANY bit depth, there is no activity on the 1622.