rolandus.com After executing WRITE procedure for approximately 500 times, the message">

Pro Audio Support

Q:
Why am I getting "User data is damaged. Factory Reset." message on my Boss DR-880
 
A:
From rolandus.com After executing WRITE procedure for approximately 500 times, the message - "User data is damaged. Factory Reset" will appear when turning on the DR-880's power, and the data stored in the user memory will be lost. This occurs when the total number of WRITE procedure exceeds 500 times, and it goes the same even if the power is turned off between times.

This is caused by the DR-880's system software, and by upgrading it, the above problem will be solved.

The latest software version can be found at the Updates&Drivers page from the DR-880 product page.



Other Popular Articles:
• ProTools is giving the message, "Could not complete the Bounce to Disk command because Assertion in FF_AudioProperty.ccp, line 33" on Mac OSX.
• Can WAV files from Acid be imported into Live?
• When I arm an audio track for recording within Logic, the corresponding fader on the ProjectMix I/O jumps to unity gain. Why is this?
• When I play a song in Ableton Live 5 that has volume level automation, the ProjectMix I/O's faders move along as they should. However, when I touch one of the moving faders, it stops moving and doesn't start again until I re-launch the software. Why is that and what can I do about it?
• The jog wheel on my ProjectMix I/O operates reversed. For example, when turning it clockwise it scrolls from right to left on my screen.